Used Equipment

Partner Hydraulic Power Unit

Price:$2950.00

Brand:Partner

Type:14HP Hydraulic (Gas)

Year:Used

Partner Hydraulic Power Unit 14HP

Engine power: Electric start Briggs and Stratton14 hp. Flow rate: 11 gpm (41 l/min) @ 1700 PSI (120Bar) Two 73 Ft (22 meter) Dash 8m hoses with HTMA flat-face standard couplings.

New engine oil and fuel filter, Removed fuel tank and flushed clean, new battery, replaced oil in hydraulic tank and flushed hydraulic lines with new AW46 Hydraulic oil. Engine runs strong, charging system working.

Flow tested hydraulic power unit under full load (1700 psi) and full rpm (3600) for 10 minutes, oil temperature 160 degrees. The results were 11 GPM (41 L/min) @ 1700 PSI (120Bar). Test shows 100% flow and pressure for horse power provided.

This unit is ready for use. This can power a full range of tools, from wall saws and large core drills to small drilling hammers, hydraulic breakers and pumps. New replacement cost for these types of unit range from $4800 to $6500. Asking $2950.00.

Reed B-50

Price:CALL FOR PRICING

Brand:Reed

Type:B-50

Year:2005

2005 Reed B-50 Trailer Mounted Line Pump with low hours comes with Pump Boss Radio Remote and hydraulic out riggers.

We have gone through this pump inch by inch and fixed every little item on it. Here is a list

New shoes for the brakes, seals and new wheel bearings.

New Tires (One had damage on inspection replaced both with new)

All the Trailer lights are operating properly.

New hydraulic oil and return filter plus cleaned tank and suction filters. We also flushed out hydraulic drive cylinders with fresh clean oil.

New engine oil, filter and air filter. Replaced battery, check fuel tank for contamination (NONE).

All control panel functions working with proper safety decals.

New hoppers grate rubbers and pivots

New concrete pistons, wear bands and oil in the water box.

Wear plate and wear ring like new 100% and installed new back up ring for wear ring.

New outlet and shaft seals for S-tube

Checked all greasing points for S-Tube throw cylinder.

Flow test main pump for operation (Excellent)

Removed and serviced alternator and starter.

Checked and cleaned all electrical connections.

Also available with pump spare parts for next service:

1 Oil filter

1 Fuel Filter

1 Proximity switch and fuse set (In control panel not required for service work)

2 piston heads

1 Hydraulic return filter

We recommend that a regular service on done on the pump and every 350-400 hours after that.

All of equipment that leaves here has our contact phone number. So you can contact us for any assistance in technical support, service or parts. Canusa Equipment Ltd. 604-526-5151.